Gaps appear in digital ink on a SMART Board 8070i interactive display
|
SMART hardware |
SMART Board 8070i interactive display |
Issue
While you write or draw on your interactive display, gaps appear in the digital ink.
Cause
This can occur if the temperature in the room changes by 18ºF (10ºC), or if the panel heats up after being used at high brightness settings for a long time.
Solution
Calibrate your interactive display.
Important
If an error message appears while you are calibrating your interactive display, contact SMART technical support.
To calibrate your interactive display
-
Press the SMART software icon in the Windows notification area or Mac Dock, and then select Control Panel.
The Control Panel appears.
-
Press SMART Hardware Settings.
-
If you have more than one SMART product connected, select the interactive display.
-
Select Advanced Settings from the drop-down list.
-
Press Calibrate.
The calibration screen appears. This can take a few moments.
-
Press the red target with the tip of a pen tray pen. Hold the tip at the center of the target until the target turns green, and then lift the pen.
The target moves to the next location.
Note
You can re-calibrate a target by pressing the LEFT ARROW key on your keyboard, or the Keyboard button or Right-click button on the pen tray.
-
Continue pressing targets until the calibration is complete.
A message appears stating that the calibration was successful, and then the orientation screen appears.
- Follow the on-screen instructions to orient your interactive display.
|
First published |
February 11, 2011 |